It's the big decision for most Sydney homeowners: one ducted system for the whole house, or split systems room by room? Both are great when they're the right fit. Here's how they compare, and the simple question that usually settles it.
The short version
| Split system | Ducted | |
|---|---|---|
| Best for | 1–3 rooms, apartments, targeted cooling | Whole-home comfort, 4+ rooms |
| Upfront cost | Lower per room | Higher, but one system does everything |
| Install time | Usually a day per unit | Usually 1–3 days |
| Looks | Visible wall unit in each room | Discreet ceiling vents, nothing on the walls |
| Noise | Quiet; unit is in the room | Very quiet; unit is in the roof |
| Running costs | Low when cooling a room or two | Efficient with zoning; higher if running the whole house |
| Apartments | Usually the go-to | Possible with a suitable ceiling space |
When a split system makes more sense
- You only need to cool a few rooms, typically the main living area and a bedroom or two.
- You're in an apartment or unit where there's no roof space for ducting. Strata rules often favour splits too.
- Budget matters now. You can start with the living room and add bedrooms later.
- You want independent control. Each room has its own unit and remote, so nobody fights over the thermostat.
When ducted is the better investment
- You want the whole house comfortable, not just one or two rooms.
- You'd otherwise need four or more splits. At that point ducted is usually comparable in cost and much tidier.
- Looks matter. No wall units, no outdoor units on every wall, just slim vents.
- You're renovating or building. It's the easiest time to run ductwork.
- It adds appeal when you sell. Ducted reverse-cycle is a feature buyers in Sydney look for.
The zoning secret
The biggest complaint about ducted, "it's expensive to run", usually comes from systems without good zoning. Zoning splits the house into areas (say, living and bedrooms) so you only cool the zone you're in. Daytime: living areas. Night-time: bedrooms. That brings ducted running costs much closer to running a couple of splits, with far better comfort.
What about multi-head splits?
A multi-head split runs two to four indoor units from one outdoor unit. It's a middle ground: fewer outdoor units cluttering the side of the house, but you still have wall units inside. It suits homes where ducting isn't practical but you want several rooms covered.
Upgrading from splits to ducted
Plenty of Sydney homes start with a split or two and move to ducted later. We've done split-to-ducted upgrades where some of the existing infrastructure could be reused, which keeps the cost down. If your old splits are near the end of their life, it's a good time to compare.
Our rule of thumb
Cooling three rooms or fewer? Splits are usually the smarter buy. Four or more rooms, or the whole house? Ducted with zoning is usually the better long-term investment. Then factor in your roof space, budget and how long you'll stay in the home. We're happy to talk it through on the phone before anyone visits.
Want rough numbers for both? Read our Sydney aircon cost guide.
Quick questions
Is ducted or split system cheaper to run?
For one or two rooms, split systems are usually cheaper to run. For whole-home comfort, a ducted system with zoning can be efficient because you only cool the rooms you're using.
Can you install ducted air conditioning in an apartment?
Sometimes. It needs suitable ceiling space and strata approval. Many Sydney apartments are better suited to split systems.
How many split systems before ducted makes sense?
As a rule of thumb, if you'd need four or more split systems, ducted is usually comparable in cost and gives a tidier, whole-home result.



